基于Pro/E的140 t/h高压辊磨机组件的有限元分析及运动学仿真
张雪娟,刘勇,李佳乐
(西华大学 机械工程与自动化学院,四川 成都 610039)
摘要:为满足砂场河卵石直接破碎粒度小于0.005 m且每小时产量为140 t/h的要求,在对辊磨机结构原理的分析基础上,确定了高压辊磨机组件设计所需的运动参数,并以Pro/E软件为建模仿真工具,针对高压辊磨机主要组件机架及磨辊进行建模和有限元分析,对满足要求的分析结果进行运动学仿真。
关键词:高压辊磨机;Pro/E;有限元分析;仿真
中图分类号:TH122;TQ172.6+11.7     文献标志码:A   文章编号:1006-0316 (2013) 07-0051-05
Finite element analysis and kinematic simulation to the 140t/h high pressure grinding rolls based on Pro/E
ZHANG Xue-juan,LIU Yong,LI Jia-le
( School of Mechanical Engineering and Automation, Xihua University, Chengdu 611930, China )
Abstract:To meet the requirements that the broken particle size of the pebbles in sunanba are less than 0.005m and the output is 140t/h, this paper, with the modeling and simulation tool--Pro/E, based on the finite element analysis to the structural principle of the roller mill, determine the required for the design of high pressure roller mill components of motion parameters and aiming at not only the the finite element analysis of the major components of the roller mill machinerack and roll grinding, but also the kinematics simulation based on the analysis results to meet the requirements.
Key words:high pressure grinding rolls;Pro/E;finite element analysis;simulation

———————————————
收稿日期:2013-01-09
作者简介:张雪娟(1987-),四川成都人,硕士研究生,主要研究方向为制造技术与特种加工;刘勇(1956-),河南沈邱人,本科,副教授,主要研究方向为制造技术与特种加工;李佳乐(1985-),四川内江人,硕士研究生,主要研究方向为机械设计与制造。
 

 

设为首页  |  加入收藏    |   免责条款
《机械》杂志版权所有     Copyright©2008-2012 Jixiezazhi.com All Rights Reserved 

  电话:028-85925070    传真:028-85925073    E-mail:jixie@vip.163.com

地址:四川省成都锦江工业开发区墨香路48号   邮编:610063

蜀ICP备08103512号

Powered by PageAdmin CMS